This trigger pin removal punch is a purpose-built tool designed to address the specific risk of frame damage when servicing the trigger assembly on SA-35, BHP (Browning Hi-Power), and Girsan MC P35 pistols. The factory trigger pin is tightly fitted, and using a standard punch often results in slipping, marring the frame, or distorting the trigger pin hole. This component provides a precisely machined, hardened steel striking surface that engages the pin correctly, allowing for clean, controlled drift removal without collateral damage to the receiver.
Compatibility
- Springfield Armory SA-35
- Browning Hi-Power (all variants)
- Girsan MC P35
Key Features
- Machined from heat-treated steel for repeated use without deformation
- Tip geometry matches the trigger pin diameter and frame clearance
- Designed to drift pin from right side, extracting left (per factory spec)
- 100% Made in USA
Install Difficulty
Difficulty: 2/5 — Requires a properly sized hammer (preferably brass or nylon), a stable work surface, and a non-marring block or padded vise to support the frame. No trigger disassembly is needed beyond pin removal. Refer to the installation video (linked below) for the correct drift direction and support method.
FAQ
Will this punch work on other Hi-Power clones?
It is confirmed for SA-35, BHP, and Girsan MC P35. Other clones may use the same pin diameter, but frame geometry varies — verify clearance before use.
Can I use this with a standard hammer?
Yes. Use a brass, nylon, or polymer-faced hammer to avoid damaging the punch handle. Steel hammers may peen the striking end over time.
Do I need to remove the grips or trigger assembly first?
No. The punch is used to drift the trigger pin out of the frame. Once the pin is removed, the trigger and associated components can be lifted out. Refer to the video for exact procedure.
All orders ship within one business day. This component is covered by the manufacturer’s lifetime warranty against defects in materials or workmanship.
Reviews
There are no reviews yet.