Extractor Kit for Springfield SA-35 and Browning Hi-Power

This heavy-duty extractor kit resolves the most common reliability issues encountered in the Springfield SA-35 and Browning Hi-Power platforms: inconsistent extraction, erratic ejection patterns, and failure to hold the case head under high round counts. The factory extractor’s claw geometry and spring tension often degrade after 500–1,000 rounds, leading to stovepipes or double-feeds. This component uses a claw profile specifically cut for the 9mm case rim and the Hi-Power slide’s extractor pocket angle. The chamber-facing hook surface allows case rim override during a failure-to-extract event caused by weak or defective ammunition. Wire EDM cut from heat-treated high-tensile tool steel, black oxide finished. Includes an extra-power extractor spring and a replacement extractor pin.

Compatibility

• Springfield Armory SA-35 (all current production)
• Browning Hi-Power (all variants, including Mk I, Mk II, Mk III, Practical, and clones with standard extractor geometry)
• FEG PJK-9HP and other licensed Hi-Power copies with non-reinforced slides

Key Features

• Claw geometry designed specifically for 9mm case rim diameter and Hi-Power extractor pocket angle
• Chamber-facing hook surface permits case rim override during ammunition-induced extraction failure
• Wire EDM cut from heat-treated high-tensile tool steel
• Black oxide finish for corrosion resistance and reduced friction
• Extra-power extractor spring increases initial tension for positive case control
• Includes replacement extractor pin (OEM-spec diameter)
• Expected results: smooth feeding from magazine, consistent positive extraction, uniform ejection pattern

Install Difficulty: 2/5

Tools needed: Punch set (1/16” and 3/32”), small hammer, roll pin holder or vise block, needle-nose pliers.
Estimated time: 15–20 minutes.
Note: Retain factory spring for spare. Ensure extractor channel is clean before installation. No fitting required on standard slides; some clone slides may need light chamfer on the pin hole.

FAQ

Will this fix ejection issues caused by weak ammunition?

The chamber-facing hook geometry is designed to override the case rim if the ammunition fails to extract normally. The extra-power spring helps maintain positive control, but this kit cannot compensate for severely underpowered or out-of-spec ammunition.

Does this work with extended slide releases or compensators?

Yes. The extractor modification is independent of slide-mounted accessories. It will function with any compensator, optic mount, or extended controls that do not alter the extractor pocket or slide rail geometry.

Do I need to replace the extractor pin or spring separately?

No. Both are included. The included pin is a direct replacement for the OEM pin. The extra-power spring is pre-tensioned; you may swap back to the factory spring if you prefer lighter tension for competition use.

Shipping: Ships within 1 business day. USPS Priority or UPS Ground available.
Warranty: This component carries a limited lifetime warranty against manufacturing defects. Springs are consumable items and are not covered after installation.