Extended Mag Release for CZ P-10 – Reversible

This extended magazine release for the CZ P-10 series replaces the factory unidirectional release with a reversible component that increases the contact surface by .100″ in length. The primary issue solved is the factory release’s limited purchase area under speed reloads or when wearing gloves; the added length and aggressive texturing provide a more positive, repeatable actuation without requiring a change in grip. This component is designed specifically for P-10 models with the newer non-ambidextrous (unidirectional) mag release system, and it can be rotated to suit either right-handed or left-handed shooters.

Compatibility

• CZ P-10 C (all generations with unidirectional release)
• CZ P-10 F (all generations with unidirectional release)
• CZ P-10 S (all generations with unidirectional release)
• Does NOT fit early production P-10 models with the factory ambidextrous release

Key Features

• Length: .100″ longer than factory release – provides additional leverage and purchase without protruding excessively
• Texture: 30 lines per inch (LPI) checkered face – consistent traction in wet, gloved, or high-speed conditions
• Reversible design: rotates 180° for left-hand operation; no additional parts required
• Material: machined from 6061-T6 aluminum, Type III hard coat anodized for wear resistance
• Weight: negligible increase over factory steel release – does not affect slide lock or trigger dynamics

Install Difficulty

2 out of 5. Required tools: small punch (1/16″) or roll pin punch, non-marring hammer, and a small flathead screwdriver. The factory release retaining pin must be drifted out, the old release removed, and the new release installed with the detent slot aligned. Expect 10–15 minutes if you have the tooling. No trigger disassembly or frame modification required.

FAQ

Will this fit my P-10 if it has the factory ambidextrous release?

No. This component is compatible only with P-10 models that use the unidirectional (single-sided) release. If your pistol has a release on both sides of the frame, this will not work without frame modification—do not attempt to force-fit it.

Does the .100″ extra length cause holster compatibility issues?

In most duty/tactical holsters with an open magwell or indexed release channel, the added length clears without binding. However, competition holsters with tight frame cuts may require slight relief. Test fitment with your holster before use.

Can I install this without removing the trigger assembly?

Yes. The mag release is retained by a single roll pin accessible through the trigger guard/frame junction. You do not need to remove the trigger, sear housing, or grip module. Follow the pin direction marked on the frame to avoid damaging the detent spring.

Shipping & Warranty

Orders placed before 2:00 PM EST ship same business day. This component carries a limited lifetime warranty against manufacturing defects. Return shipping is covered if the part is defective; non-defective returns accepted within 30 days (minus shipping).