Flat-Faced Forward Set Sear & Trigger Kit for M&P

This flat-faced forward set sear and trigger kit replaces the factory M&P fire-control group to address the two most common complaints with the platform: excessive pre-travel and a long, spongy reset. By repositioning the sear engagement geometry and incorporating a pre-travel stop, the kit reduces overall trigger travel by approximately 40% while delivering a clean, single-action-like break. The flat shoe provides a consistent finger placement index, aiding repeatable press mechanics under speed. Designed for shooters who need a predictable pull weight between 3–4 lbs without compromising the striker-fired safety system.

Compatibility

• Smith & Wesson M&P 9mm (full-size, compact, Shield excluded)
• Smith & Wesson M&P 40
• Smith & Wesson M&P 45 (full-size only)
• Smith & Wesson M&P 2.0 (all calibers, full-size and compact)
• Not compatible with M&P Shield, M&P 22, or Performance Center ported models without verification

Key Features

• Drop-in replacement – no hand-fitting, sear engagement adjustment, or trigger bar bending required
• Pull weight adjustable via spring selection (3.0–4.0 lbs using included springs; 4.5–5.5 lbs using factory springs)
• Pre-travel reduced by ~40% compared to factory configuration
• Over-travel stop integrated into the shoe design
• Reset distance shortened by approximately 30%
• Center-mounted pivoting safety maintains factory drop-safety compliance
• Flat shoe profile with textured face for consistent index

Install Difficulty

2 out of 5. Requires basic armorer-level tools: 1/16” punch, small hammer, and a slave pin (or paperclip) for the trigger bar spring. No stoning, filing, or polishing required. Expect 20–30 minutes for first-time installation.

FAQ

Will this work in an M&P 2.0 with the newer trigger bar?

Yes. This kit is compatible with both 1.0 and 2.0 M&P frames. The forward set sear geometry interfaces directly with the slide’s striker block, regardless of trigger bar generation.

Does the flat shoe change the trigger reach for smaller hands?

The shoe is positioned slightly forward relative to the factory trigger’s resting position, which may reduce reach for shooters with shorter fingers. If you have longer fingers and prefer a more rearward start point, consider pairing with an adjustable trigger stop.

Can I use this for USPSA Carry Optics or Limited?

Yes. The 3–4 lb pull weight and short reset make it suitable for competition use. The kit maintains the required 5 lb minimum pull for Production division when using the heavier spring set (included). Verify local division rules for trigger modifications.

Ships within 1 business day. Limited lifetime warranty against manufacturing defects – covers sear, trigger shoe, and springs. No returns on installed parts. If you have questions about fitment for a specific M&P variant, contact us before ordering.