Armorer’s Tray & Pin Punch

The Armorer’s Tray & Pin Punch is a dedicated work-surface tool designed to keep small components contained and your bench protected during Glock and S&W frame work. It solves the problem of lost detents, flying trigger pins, and marred frames by providing a magnetized, recessed catch area that captures steel parts as they exit the lower receiver. Paired with the Armorer’s Block (sold separately), this tray centralizes the disassembly process so you spend less time searching for dropped parts and more time on the bench.

Compatibility

• Glock 17, 19, 19X, 26, 34, 43, 43X, 48
• Smith & Wesson M&P full-size, Compact, Shield (standard frame)
• Fits under the Armorer’s Block (block not included)
• Accepts standard 1/16” Allen wrench (included)
• Holds the Heavy Duty Armorer’s Punch (included)

Key Features

• Magnetized catch surface – Ring magnet on the underside retains steel pins, springs, and disconnectors after removal from the frame.
• Recessed center well – Lowered surface captures parts as they exit, preventing roll-off onto the floor or into the trigger guard.
• Muzzle capture post – Raised center boss holds the slide muzzle to protect the work surface when removing back plates.
• Bump-loc Allen wrench storage – Small raised bumps secure the included 1/16” Allen wrench in the lowered surface.
• Grasping finger slots – Molded cutouts provide secure storage for the included Heavy Duty Armorer’s Punch.
• High-density polymer – Non-marring material prevents frame scratches during disassembly.
• Included punch – Heavy Duty Armorer’s Punch with a hardened tip for pushing out trigger pins and slide cover plates.
• Included wrench – 1/16” Allen wrench for trigger over-travel stop adjustment.

Install Difficulty: 1/5

No installation required. Place the tray on a flat bench, set the Armorer’s Block (sold separately) on top, and begin disassembly. Tools needed: Armorer’s Block (sold separately), the included punch, the included Allen wrench.

FAQ

Does this tray work without the Armorer’s Block?

Yes, the tray functions as a standalone parts catch and punch holder. However, the block is recommended for stabilizing the pistol frame during trigger work.

Will the magnet hold steel pins securely?

The ring magnet is designed to retain standard steel Glock and M&P trigger pins, slide stop pins, and springs. It will not hold non-ferrous parts (aluminum or polymer).

Is the punch hardened or will it deform on roll pins?

The included Heavy Duty Armorer’s Punch has a hardened tip suitable for pushing out Glock trigger pins and slide cover plates. It is not rated for heavy hammer strikes on stubborn roll pins—use a dedicated roll-pin punch for that application.

Shipping & Warranty
Ships same business day if ordered by 2 PM ET. This product carries a limited lifetime warranty against manufacturing defects. Contact us for warranty claims or replacement parts.