This extended bolt handle from the kit replaces the factory FN SCAR charging handle to provide additional clearance between the shooter’s hand and mounted optics. The factory handle’s proximity to scope bodies, red dot housings, or magnifiers often results in pinched fingers or torn knuckles during rapid manipulation. By extending outward from the upper receiver, this component eliminates that interference while maintaining a low-profile footprint that does not snag on gear. The handle is reversible and can be flipped to either side of the receiver, making it suitable for left-handed shooters or those running offset optics configurations. The large lobe design provides a positive purchase surface for gloved and ungloved operation alike.
Compatibility
- FN SCAR 16 (5.56mm) – all variants
- FN SCAR 17 (7.62mm) – all variants
- FN SCAR 20S
- Does not fit NRCH (Non-Reciprocating Charging Handle) models without modification
Key Features
- Extended length: 0.75” farther from receiver than factory handle
- Reversible and flip-able orientation: ships symmetrical, user-configurable for left/right or forward/rearward cant
- Large lobe surface area: 1.2” wide textured pad
- Material: 7075-T6 aluminum, Type III hard coat anodized
- Weight: 0.9 oz (adds negligible mass over factory steel handle)
- Installation: drop-in, no permanent modification to receiver
Install Difficulty: 2/5
Requires a 3/32” punch and a soft-faced mallet to drift out the factory retaining pin. No filing, fitting, or receiver disassembly needed. Typical install time under 5 minutes. Do not use steel punches on the anodized aluminum—use brass or nylon to avoid marring the finish.
FAQ
Will this handle work with a suppressor-height front sight or thermal optic?
Yes. The outward extension provides additional stand-off from the receiver top, clearing most 30mm and 34mm scope bodies, as well as clip-on thermal devices mounted forward of the ejection port. If your optic’s eyepiece overhangs the charging handle channel, this handle will clear it.
Does this handle reciprocate with the bolt on a SCAR 16/17?
No. The SCAR’s charging handle is non-reciprocating on standard models. This handle replaces the factory non-reciprocating handle and does not move during firing. For NRCH models (SCAR 16S NRCH, SCAR 17S NRCH), the handle remains stationary but the factory latch mechanism differs—confirm your model before ordering.
Can I run this handle on the left side for a southpaw setup?
Yes. The handle is fully reversible. Remove the retaining pin, flip the handle 180°, and reinstall. The lobe can also be canted forward or backward by rotating the handle body before pinning. No additional parts required.
Shipping & Warranty: Ships within one business day via USPS Priority or UPS Ground. Backed by the manufacturer’s limited lifetime warranty against defects in material and workmanship. No-hassle returns accepted within 30 days of delivery if product is unused and in original packaging.
Reviews
There are no reviews yet.